IMC Bartender Worktop Units

Worktop unit for the IMC Bartender Modular Bar System
Units are 950mm high (850mm to worktop) x 560mm deep (475mm to worktop)


Please note that this unit is supplied with one leg frame only, in a run of equipment this unit shares a leg frame with the next unit along. At the end of the bar run, or where a bridge section is used an additional leg frame will be required - this can be ordered separately.

We can offer full design and installation packages on our range of stainless steel modular bar systems - please contact us for further details

Worktop unit for the IMC Bartender Modular Bar System
560mm wide for corner operation
Units are 950mm high (850mm to worktop) x 560mm deep (475mm to worktop)

Image shows option with inset Square sink available below

Please note that this unit is supplied with one leg frame only, in a run of equipment this unit shares a leg frame with the next unit along. At the end of the bar run, or where a bridge section is used an additional leg frame will be required - this can be ordered separately.

We can offer full design and installation packages on our range of stainless steel modular bar systems - please contact us for further details

Perforated worktop unit for the IMC Bartender Modular Bar System
Units are 950mm high (850mm to worktop) x 560mm deep (475mm to worktop)


Please note that this unit is supplied with one leg frame only, in a run of equipment this unit shares a leg frame with the next unit along. At the end of the bar run, or where a bridge section is used an additional leg frame will be required - this can be ordered separately.

We can offer full design and installation packages on our range of stainless steel modular bar systems - please contact us for further details

Perforated worktop unit with beer fonts for the IMC Bartender Modular Bar System
Top reinforced to allow mounting of beer fonts
Please note that we will require templates for your chosen bar fonts to manufacture these modules specific to your requirements
Units are 950mm high (850mm to worktop) x 560mm deep (475mm to worktop)


Please note that this unit is supplied with one leg frame only, in a run of equipment this unit shares a leg frame with the next unit along. At the end of the bar run, or where a bridge section is used an additional leg frame will be required - this can be ordered separately.

We can offer full design and installation packages on our range of stainless steel modular bar systems - please contact us for further details